Titan Motorsports 2JZ-GTE Stage 3 Head: Street / Race
Our most popular cylinder head. It is suggested to run a built or prepped short block for this head package. This is the same cylinder head that was developed in the famous Titan Motorsports Pro Street Tire Supra and pushed it into the 7s in the ¼ mile to be the fastest street Supra at the time. Since then this head has even been used on pro chassis cars to run low 6s. We start by cleaning, and pressure checking the core cylinder head, then remove the valve guides and do a full CNC port and polish including CNC the combustion chambers. We plug the additional water passages that are not needed for a performance head. The valve job is done on a Newen Contour machine that creates the optimal valve seal machining and angle. Then full re-assembly is done with Ferrea Guides, Ferrea Dual springs, Titanium retainers, seats/locks and +1mm valves.
As an option we can install our custom shimless buckets which are not available at any ordinary shop. These buckets must be installed for the specific cam that you have, cams must be supplied or purchased and will be set and shimmed for each specific head. This allows you to safely rev above 9000rpm if you so desire. The shimless buckets weigh half the weight of the stock bucket and also prevent from the common shim spitting that can occur with very high revving engines.
The extra attention and detail and custom manufacture of hardcore specific parts makes the Titan Motorsports head package above and beyond other heads that use plain off the shelf parts. If your looking for serious performance, you found it.
*Note: You must send us your good head core.